| PRODUCTS |
FUNCTION |
APPLICATION RATE |
| SANDSEAL POWDER |
Core gap filling/ parting line filling |
Mix. Powder with water in the ratio 100 : 25 (Powder : water) allow to soak for minimum 12 hr and apply by finger |
| CORESTIC-8-RED |
Core gum for shell core & moulds |
Use as it is by applying on shell core surface & moulds |
| CRAFTCOTE-AVC |
Antiveining for cold box and No- Bake core |
Take requisite quantity of sand in Muller and add recommended Craftcote-AVC 0.5 to 1.50% by weight of sand. Mix for 2- 3 minutes and then add binder.
|
| SHELLRELEASE-W |
Water base shell part |
Initially spray throughout the pattern. Subsequently when a fine film of silicon oil is formed on dies / pattern then frequency can be reduce depending on integracy and geometry of the die / pattern. |
| SHELLRELEASE-K |
Mineral oil base shell part |
Initially apply the spray throughout the pattern for stripping. Subsequently when a fine film of silicone oil is formed on dies / pattern then the frequency can be reduce depending on integrity and geometry of the die / pattern.
Advantage: Temperature drop will be less. |
